FireNet Community

FIRE SERVICE AND GENERAL FIRE SAFETY TOPICS => Technical Advice => Topic started by: Davro on January 26, 2008, 06:31:20 PM

Title: Firesense Concept
Post by: Davro on January 26, 2008, 06:31:20 PM

Does anybody out their know much about these panels,and if any one has a manual on these panels would be great.I know the basics but i would like the manual so i would be able to carry out one man walk tests etc.

Title: Firesense Concept
Post by: Benzerari on January 26, 2008, 09:13:19 PM

Quote from: Davro

Does anybody out their know much about these panels,and if any one has a manual on these panels would be great.I know the basics but i would like the manual so i would be able to carry out one man walk tests etc.

If I remember it is switch No2 that should turned OFF to have OMT... but if not a 'Twin-Wire' system just remove the fuses of the outputs ( Relays and sounders) and that would be 'silent mode' not just 'walk test'

Title: Firesense Concept
Post by: Daren Pool on January 27, 2008, 11:07:59 AM

Hi Buddy

Let me know which model it is an an email address and i will send one over to you in pdf format.

Daren
Triple Star Fire Limited
Mob: 07984 530 357

Title: Firesense Concept
Post by: Galeon on January 31, 2008, 09:22:55 AM

By putting this panel into one man test ,does it report a fault condition ? , I seem to remember on the early panels you can walk away from the panel and it could be left in test mode - check this out.