FireNet Community

FIRE SERVICE AND GENERAL FIRE SAFETY TOPICS => Technical Advice => Topic started by: Davro on January 01, 2009, 10:42:04 PM

Title: CLYMAC
Post by: Davro on January 01, 2009, 10:42:04 PM

How do you disable the conventinal sounder circuit/relay contacts and the printer with out disconnecting the cables?

Title: Re: CLYMAC
Post by: Goodsparks on January 02, 2009, 04:23:20 PM

I think disabling zone 45 (or 49 ?) disables the outputs / sounders on the ZP3.

Paul

Title: Re: CLYMAC
Post by: JonnyG on January 02, 2009, 10:19:32 PM

Depends how it's been programmed, It's zone 50 over here...

Title: Re: CLYMAC
Post by: Davro on January 02, 2009, 11:25:43 PM

The panels i work on is zone 50 loop sounders and zone 49 for loop relays, but i want to know how to disable the conventinal sounders/relay contacts. Thanks for the reply tho.

Title: Re: CLYMAC
Post by: JonnyG on January 03, 2009, 12:18:52 AM

Initial have recently merged with us and they worked mainly on clymac, I'll ask on monday mate. I would like to know too!!

Title: Re: CLYMAC
Post by: Davro on January 05, 2009, 09:07:18 PM

Initial you say, would there be any chance they would give out there comissioning code as i have taken over one of there systems and would like to add devices on loop. Also would like to know how to disable printer at same time of service.

Title: Re: CLYMAC
Post by: dark one on February 03, 2009, 07:55:27 PM

disable of the panel sounders can be done in setup sytem config, relays, sounder relay but is easier to pull fuses f2,f3,f7&f8 located below sounder terminals