« previous next »
Pages: [1]   Go Down

Author Topic: CLYMAC  (Read 5054 times)

Offline Davro

  • Jr. Member
  • **
  • Posts: 75
CLYMAC
« on: January 01, 2009, 10:42:04 PM »
How do you disable the conventinal sounder circuit/relay contacts and the printer with out disconnecting the cables?
Logged

Offline Goodsparks

  • Jr. Member
  • **
  • Posts: 73
Re: CLYMAC
« Reply #1 on: January 02, 2009, 04:23:20 PM »
I think disabling zone 45 (or 49 ?) disables the outputs / sounders on the ZP3.

Paul
Logged

Offline JonnyG

  • Newbie
  • *
  • Posts: 49
Re: CLYMAC
« Reply #2 on: January 02, 2009, 10:19:32 PM »
Depends how it's been programmed, It's zone 50 over here...
Logged

Offline Davro

  • Jr. Member
  • **
  • Posts: 75
Re: CLYMAC
« Reply #3 on: January 02, 2009, 11:25:43 PM »
The panels i work on is zone 50 loop sounders and zone 49 for loop relays, but i want to know how to disable the conventinal sounders/relay contacts. Thanks for the reply tho.
Logged

Offline JonnyG

  • Newbie
  • *
  • Posts: 49
Re: CLYMAC
« Reply #4 on: January 03, 2009, 12:18:52 AM »
Initial have recently merged with us and they worked mainly on clymac, I'll ask on monday mate. I would like to know too!!
Logged

Offline Davro

  • Jr. Member
  • **
  • Posts: 75
Re: CLYMAC
« Reply #5 on: January 05, 2009, 09:07:18 PM »
Initial you say, would there be any chance they would give out there comissioning code as i have taken over one of there systems and would like to add devices on loop. Also would like to know how to disable printer at same time of service.
Logged

Offline dark one

  • Newbie
  • *
  • Posts: 25
Re: CLYMAC
« Reply #6 on: February 03, 2009, 07:55:27 PM »
disable of the panel sounders can be done in setup sytem config, relays, sounder relay but is easier to pull fuses f2,f3,f7&f8 located below sounder terminals
Logged
Pages: [1]   Go Up
« previous next »